X Research source Take the right hand paracord, and fold it to the left, across the two center cords. To make the next knot, follow the same instructions, except reversed to the other side.X Research source Then pull the loose ends tight. X Research source Then take the right hand paracord, and pass it on top of the tail end of the left side paracord, under the two center cords, and up through the loop created by the left hand paracord. Take the left hand paracord, and fold it to the right, over and across the two center cords. You will be knotting onto the two center cords running 5 inches down from the base of the carabiner. The two end sides of the paracord are the two cords you will be knotting to create the cobra stitch. X Research sourceĬobra stitch the paracord. The center of the paracord (marked) should be in the middle of that two-inch loop.Make sure the looped side of the lanyard knot has about a two-inch loop. Gradually pull and tug on both tag ends of the paracords while holding onto the looped cord. Tear off the piece of paper, and hold onto the looped cord that was on the other side of the paper.Bring the upper paracord tail around to "trace" the left of the knot, past the bottom hole where the other cord is coming from, underneath all the lower cords, to come up through the “eyeball” center of the knot.The same technique will be used for the other tag end of the paracord. Take the tag end of the paracord coming from the bottom of the knot, bring it around to "trace" the right of the knot, past the top hole where the other cord is coming from, and underneath all of the upper cords, to come up through the “eyeball” center.You should have a very elaborate and mirrored knot pattern. Feed the tag end of the top paracord down through the right side of the “eyeball,” underneath the “pupil,” and up through the left side of the “eyeball.” Gently pull both tails of the cords to tighten the knot just a little bit.Also place the upper cord underneath the bottom loop’s tail cord. For example, the top cord should look like a center “pupil” running through an “eyeball” (the loop). Have the cord sit through the middle of the loop. Then take the paracord passing through the top hole, and place it underneath the bottom paracord’s loop.Take the paracord passing through the bottom hole of the paper, and make a loop near the paper hole.You will need about a two-inch loop by the time you’re finished with the knot, so having the cords pulled flush against the paper can help you achieve this. Pull the cords all the way through the paper so there is no visible loop hanging on the left side, but rather, the "loop" is flush against the paper. Feed the loose ends of the paracord through the holes in the paper, and have the looped end of the cord on the left side of the paper, while the loose ends through the paper go off to the right. Poke two holes vertically, on top of each other, about 4 inches apart through the middle of the paper. If you are tying this knot for the first time, it may be beneficial to use a sheet of paper to visualize how the cords intertwine to tie the know.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |